ROUND Pools Ambassador User Manual download pdf (Page 30)

TYPE # 3 – J or V-BEAD LINER:

• With a V-Bead liner you will not use the plastic coping strips that

are packed in the parts carton of your pool. You can discard those

pieces, if they are included, as they only apply to pools with

overlap liners.

• The top of the wall of the liner has what is called a “V-Bead”

welded onto it. Simply open up the bead with your fingers and

hang it directly on top of the pool wall. When this is done

properly, the only portion on the outside of the pool wall is

approximately 1” of the V-Bead. No printed liner material is

actually going over the top of the wall to the outside of the wall.

• Make sure the bead is on evenly around the entire pool, and that

the liner is hanging straight down from the top of the wall. The

liner should not have creases in it because it is twisting around

the pool. If the liner is twisting, it is because it is not sitting

properly in the pool. Make necessary adjustments before proceeding.

Pool

Water

Inner Stabilizer Rail

(supplied with pool)

Pool Wall

V-Bead

Liner

J or V-BEAD LINER

STEP 18: HANGING LINER continued

Once the liner is held securely in place by coping, temporarily pull wrinkles in the floor towards the side wall evenly,

leaving the wrinkles at the cove. When the liner is correctly positioned, there must be no air space between the liner and

the ground or side wall. Remove wrinkles at the cove by adjusting the amount of material over the wall. Do not pull too

tight- leave the slack on the sides. When a liner is properly installed there is no downward pressure on the liner. The liner

could pull in if it is hung too tightly.

Start filling the pool. When the water is no more than 1” deep, check for levelness. If water runs to one side, pull

back the liner and make the ground level. When level, continue to fill and adjust the liner. Do not cut the skimmer and

skimmer return holes in the liner until fully adjusted and the pool is 1/3 filled.

INCORRECT!

DO NOT LEAVE A GAP BETWEEN LINER

AND COVE. THIS WILL CAUSE DOWN-

WARD PRESSURE ON THE LINER.

CORRECT THIS CONDITION IF IT OCCURS.

CORRECT

NO AIR SPACE BETWEEN

LINER AND POOL - SLACK ON SIDES.

STEP 19: LINER ADJUSTMENT (For Overlap liners ONLY)

Fig. 62

Fig. 63

Fig. 64

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

ROUND Pools Ambassador User Manual Page 30

Comments to this Manuals

Related products and manuals for Above ground pools ROUND Pools Ambassador